Description
Can't see the colour or number of sheets you want? Drop us a message - we can get more stock!
Treadmaster is a fantastic product for all boats - whether you have a RIB, sailing boat of any other kind of inflatable. It's often used for whole deck coverings on any boat type, wear patches on RIB tubes or areas needing a low slip surface - like transoms, steps and access ladders on yachts and motor boats.
These Choice B sheets of Treadmaster Diamond Pattern are just like our normal sheets, but discounted as they failed quality inspection. This could be for one or more of the following reasons:
- More cork showing on the top surface than normal
- Pattern not as sharp as it should be
- Contamination/stain - which might even clean off!
- Tear/slit - we have listed these at a slightly lower price again and descriptions are below for these specific sheets
If the issues were spotted early, the sheets may not have been trimmed down to size and may therefore be oversized and need the edges trimming.
These sheets are choice B for the types of cosmetic issues listed above - they are not a reduced price because they are expected to wear quicker or fade any differently to a standard sheet.
Whilst we can not photograph each sheet separately, if you would like to see a photo of a sheet prior to purchase we can send a photo taken at about 1m/waist height using an iPad.
All photos on this listing are of the normal Treadmaster Sheets, other than those with "Choice B" across them which are to show examples of the faults you may have on the sheets you receive.
Sheet specific issues
-
Black - faults include imperfection on rear - These sheets have missing material on the back. This runs down part of the length of the sheet, and parallel to the edge (approximately 35cm from the edge). The top surface does not look to be affected by this issue. The sheets may or may not have imperfections on the top surface too.
-
Black - has 7cm tear - This single sheet has a 7cm tear. The tear starts on the 900mm edge and runs vertically down the sheet. The tear is positioned 15cm to the left of the top right corner of the sheet. (The sheet could be flipped so it's 15cm in from the bottom left corner). The sheet may or may not have other imperfections on the top surface too.
-
Grey - has 4cm tear and missing corners - This sheet is oversized and when trimmed will have a small amount of the top right and bottom right corners missing. It also has a 4cm tear in the top left. Tear is approximately 45cm down the 1200mm edge, and 23cm in on the 900mm edge.
Here's all the normal information about Treadmaster Diamond Pattern sheets:
- Sheet size: 900 x 1200mm
- Sheet thickness: 3mm
- Available colours: Black, Blue, Fawn, Green, Grey, Light Blue, Light Grey, White Sand
- Fix to GRP/fibreglass, wood and metal using Treadmaster 2 part marine epoxy adhesive (1 set will fix 2 sheets)
- Fix to hypalon tubes using ToobBond - RIBstore's 2 part hypalon adhesive
- Made in Cornwall, by Tiflex
